Helical Gear Worm Reducer Motor Small Pinion High Speed Reducer Worm Reducer Gearbox

Översikt

Snabbinformation

Ursprungsort:

Zhejiang, Kina

Varumärke:

EPT

Växelarrangemang:

Mask

Utgående vridmoment:

19-2745N.m

Ingångshastighet:

1500r/min

Utgångshastighet:

14–186 varv/min

Tillämpliga branscher:

Manufacturing Plant

Lager:

C&U

Material of Housing:

Casting Iron

Monteringsposition:

Foot mounted, flange mounted

Oil seal:

NAK

Storlek:

40-250

Rtio:

10,15,20,25,30,40,50,60

Material of Shaft:

kromstål

Output Form:

Solid shaft, hollow shaft

Färg:

Green,yellow or according to arequirment.

Product name:

transmission gearbox

Förpackning och leverans

Selling Units:

Single item

Single package size:

28.7X20.6X21.5 cm

Single gross weight:

17.0 kg

Package Type:

cartons&wooden cases or according to customer's requirement

Bildexempel:

Ledtid
:

Quantity(Pieces)	1 – 10	>10
Uppskattad tid (dagar)	15	Ska förhandlas fram

Online-anpassning

FEATURS:

1.widely used in turbines, shaft liners and axletrees;good resistance to wear, with high precision in dimensions,low noise, advanced centric runningcastings.

2.With air vent and highprecision.

3.The structure is compact and the weight is large.

4.Packing:wooden cases or can be according to customer’s requriements.

NOTICE:

1. notice of installation

1.1 The base-plate must be plane and stoutness and the base-plate must be screwed down and shock proof.

1.2 The connecting shaft of prime mover, reducer and operation device must be coaxial installation.

1.3 The diameter tolerance zone of input and output shaft is H6, the holes of fittings( such as couplings, belt-pully, sprocket wheel and so on) must properly mate the shaft, which prevents bearing from breakage because of over-loose mate.

1.4 Drivers such as sprocker wheel and gear must be fitted close to bearings in order to reduce bending stress of hanging shaft.

1.5 While assembling motor of WPD reducer, it is necessary that proper amount of butter applies to the warm shaft input hole and keyway, avoiding assembling too tightly and rusting after using for a long time.

1.6 When ordering or using all kinds of WPD type, if the motor weight is binger than the common,supporting set is required.

2.notice of usage

2.1 Before using,please check carefully whether the reducer modle, distance, ratio, input connecting method , output shaft structure, input and output shaft direction and revolving direction accord with required.

Lager	C&U
Material of Housing	Casting Iron
Monteringsposition	Foot mounted, flange mounted
Oil seal	NAK
Storlek	40-250
Rtio	10,15,20,25,30,40,50,60
Material of Shaft	kromstål
Output Form	Solid shaft, hollow shaft
Färg	Green,yellow or according to arequirment.
Produktnamn	transmission gearbox